How to Fix Canon MX328 Printer Error 6000 Manual

Canon printers are extremely advanced printers but due to various external interruptions, they can be subject to certain problems or issues. One of such issues is Error 6000

When Error Message 6000 occurs in your Canon Printer MX328, first you need to turn your printer off and then turn it on. If the error still persists, there may be some technical error that is blocking your paper feed tray from opening.

If any document or many surrounds your printer from where your printer ejects paper, you need to clear that passage of the passage tray so that the print comes out without obstacle. Now, turn your printer off and switch it on again. Your printer will now be ready for printing.

If the error still persists in your printer, you need to contact our Technical Support Team.

These can be the certain causes, due to which the error occurs

  • Your printer’s paper feed tray might have not been opened properly
  • The error may also persist at the time of printing many documents in large quantity.

Your printer’s paper feed tray might have not been opened properly

If you give print command when the tray is closed or not opened properly. The Error Code 6000 will appear.

Check if there is any physical object that is blocking the paper tray? Remove the obstacle. Turn your printer off and then turn it on. Now, give your printer the print command.

The error may also persist at the time of printing many documents in large quantity

This can be a probable reason for the error code 6000, however, both the above-mentioned reasons bear the same solution method.

What Solution Do You Need to Follow?

Solution No. 1

  • Turn your printer off properly
  • Now, long press the stop/reset button
  • Long press the Power ON Button
  • Once you hold the power ON button, leave the Reset/Stop button.
  • Now, keep on holding the Power ON Button and go to the Reset/Stop button: Press it twice.
  • Now, leave the power button
  • Now, wait for the time it shows message Idle. It might take a minute
  • Once the message appears, open to the cartridge by opening the top cover.
  • Gently levity the holder of Cartridge cover and take out both the cartridges: Colour and Black.
  • Make sure you set the cartridge cover holder back and turn the printer off.
  • Once the printer initializes successfully, Install both the cartridges.

Solution No. 2

Now, long press the stop/reset button and wait for the printer to start again.
Now, wait for the few seconds until it restarts completely.

Our Assistance

You can connect with our technical support team for more assistance if your printer is facing this issue coupled with many other issues. Our Technical Support Team is available all the time to provide you complete guidance and assistance without any delay. Call us on our Toll-Free Number <XXXXXXXXXXXX> or connect with us via our official email address <XXXXXXXXXX>

Leave a Reply

Your email address will not be published. Required fields are marked *